QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 44)

0$7

$



5 If you need to remove a SIMM

before installing one, remove it as

follows; otherwise go to step 6.

»Note:

If all the SIMM connectors are

filled and you want to install more

memory, you have to exchange one

or more SIMMs for SIMMs with a

greater memory capacity.

a Using your thumbs, pull the

latches (one on each side of the

SIMM connector) outward.

b Tilt the SIMM backwards to a

45° angle away from the SIMM

connector.

c Lift the SIMM out.

6 Remove the new SIMM from its anti-static bag.

7 Insert the new SIMM into the

SIMM connector.

a Hold the SIMM at a 45° angle

to the controller board, with the

notch on the right side and the

bottom edge in the connector.

»Note:

You can insert a SIMM in

any SIMM connector as long

as DRAM0 and the SIMM

connector before the one

you’re installing are occupied.

...................................................

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 99 100

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 44