QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 51)

100

&#0

9(#

8!+$38#9(# 

where

filename

refers to the name of the system software file (systemdl.ps is a

typical name) and # is the number of the serial port on the PC (/b refers to binary

files.)

The Downloading process takes about 15 minutes depending on the size of the

file and the speed of your computer. The Ready LED blinks as the new system

image is copied to the printer.

5 While the system software is loading, the Online LED blinks off and on, and

the message window displays

Downloading image

via serial port.

6 After the new system software has been written to ROM, the printer returns

to IDLE.

»Note:

The new system image doesn’t erase the old image until the printer verifies

that the new image is valid.

7 Restart the printer to activate the new system software.

8 Print another advanced status page, and verify that the configuration set-

tings are the same.

%!$%—&

1 Open an ftp session at your PC or workstation by typing one of the follow-

ing commands:

ftp

printername

↵ (for example, ftp pctdev6↵)

ftp

ipaddress

↵ (for example, ftp 161.33.130.45↵)

2 When prompted for a user name and password, press Enter.

An ftp> prompt displays.

3 At the ftp> prompt, change to binary mode by typing

bin↵

4 At the ftp> prompt, send the system software file to the printer’s hard disk

by typing

put

filename

.ps↵

where

filename

refers to the name of the system software file (systemdl.ps is a

typical name).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 51

Kommentare zu diesen Handbüchern