QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 65)

/$#

/$#8%8#"9(# )

%

Optional emulations, such as CGM, LN03 Plus, and XES/UDK, are available as Post-

Script files on floppy disks. This section describes how to download an optional emu-

lation to the printer’s hard disk.

»Note:

You must have at least one hard disk, internal or external, attached to the

printer in order to use an optional emulation. If more than one hard disk is available,

the emulation automatically installs itself on the disk with the most free storage space.

QMS recommends that you have at least 4 MB of memory above the base

configuration and that you add at least 1 MB memory to each emulation installed. This

ensures that the printer can run the emulation without slowing down performance.

'+

)!!!!*$

1 Turn on the printer, and wait for IDLE to appear in the message window.

2 Insert the emulation disk in your computer’s 3.5" disk drive, and change to

that drive (for example, if you’re using the A drive, type a:↵).

3 Send the emulation to the printer’s hard disk.

 If your computer and printer are connected through the parallel port, type

copy /b *.ps lpt#↵

where

is 1 to 3. (/b refers to binary files.)

 If your computer and printer are connected through the serial port, type

copy /b *.ps com

↵

where

is 1 to 4. (/b refers to binary files.)

4 When downloading is complete, reboot the printer.

The emulation should be listed in the Options section of the printer’s start-up

page, in the Administration/Emulation printer’s configuration menu, and on the

advanced status page.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 99 100

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 65