QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 52)

&#0

9(#



5 While the system software is loading, the Online LED blinks off and on, and

the message window displays

Downloading image

6 At the ftp> prompt, end the ftp session by typing

quit↵

7 When the Online LED stops flashing and the printer’s message window

reads Idle for at least 30 seconds, turn the printer off and then on again.

8 Restart the printer to activate the new system software.

9 Print another advanced status page, and verify that the configuration set-

tings are the same.

»Note:

The system software can also be downloaded using CrownAdmin software

utilities if you have CrownAdmin installed and you are familiar with it.

&—%

%!$%—&

1 Start CrownAdmin Software Utilities on you Macintosh.

»Note:

If you don’t have CrownAdmin installed use the QMS Software Utilities

CD-ROM to install it.

2 Select the printer from the printer list area.

3 From the File menu, select Print.

4 In the Print File window, select Browse.

5 Select the new system software file where it is stored (on CD-ROM or on

your hard disk.)

6 Click Print.

7 When the Online LED stops flashing and the printer’s message window

reads Idle for at least 30 seconds, turn the printer off and then on again.

8 Restart the printer to activate the new system software.

9 Print another advanced status page, and verify that the configuration set-

tings are the same.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 52