QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 81)

#$'#+3

#0+ )

4 If you need to remove

a hard disk before

installing one, remove

it as follows; other-

wise skip to step 5.

a Place your left hand

on the metal

interface plate, the

thumb on your right

hand on top of the

hard disk, and the

other fingers on

your right hand underneath the corner of the hard disk, and then pull up gently

but firmly on the hard disk. The disk is firmly seated, so it may take several

tries to remove it.

b Unplug the ribbon cable connector from its mating connector on the controller

board.

▲ Caution:

Don’t push or pull with the ribbon cable. Use the cable connector.

5 Attach the IDE hard

disk to the hard disk

bracket.

Attach the IDE hard disk

to the bracket with the

grooved-end of the

bracket facing the ribbon

cable. The screw holes in

the bottom of the hard

disk should match up

with the holes on the

hard disk bracket. Fasten

the hard disk to the

bracket with the screws provided.

6 Position the hard disk so that the four support posts face the controller

board, the colored stripe on the ribbon cable faces away from you, and the

connector is down.

...................................................

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 99 100

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 81