QMS SC-100 Einstellungsanleitung PDF herunterladen (Seite 49)

&#0

9(#

8!+$38#9(# .

tacting our Customer Response Center, or the system software can be shipped to you

on CD-ROM or diskettes. If you get diskettes use the following procedure to unzip the

system software on the diskettes using a PC.

Make sure that you have a copy of the advanced status page from your printer so that

you can restore settings after updating the system software.

$%$

»Note:

It is not necessary to decompress the system software if you downloaded it

from the QMS website or received it on CD-ROM.

1 Switch to the MS-DOS prompt.

2 Create a new directory on your PC. Type

:\mkdir

newdir

↵

where

newdir

refers to the name of the new directory where your system software

will be stored and

: is the hard drive designation.

3 Change to this directory. Type

:\cd

newdir

4 Insert the printer system software disk in your PC’s 3.5" disk drive.

5 Type

:\pkunzip

:\system↵

where

is the name of the disk drive in which you inserted the system software

disk.

6 Follow the prompts.

They instruct you to insert the system software disks in the following order:

a Last disk (system software disk 3)

b Disk 1 (system software disk 1)

c Disk 2 (system software disk 2)

d Disk 3 (system software disk 3)

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 99 100

Keine Kommentare

QMS SC-100 Einstellungsanleitung Seite 49